Rear Axle

Setting of T.J. Boot Length
Conventional Differential
Standard Value 79 ± 3 mm (3.11 ± 0.12 inch)
Limited Slip Differential
Standard Value 84 ± 3 mm (3.31 ± 0.12 inch)

Drive Gear Backlash
Standard Value 0.11-0.16 mm (0.0043-0.0063 inch)

Differential Gear Backlash
Conventional Differential
Standard Value 0-0.076 mm (0-0.0030 inch)
Limit 0.2 mm (0.008 inch)
Limited Slip Differential
Standard Value 0.03-0.09 mm (0.001-0.004 inch)

Drive Pinion Turning Torque
Without Oil Seal
New Bearing
Standard Value 0.9-1.2 Nm (8-10 inch lbs)*1
New or Reuse Bearing
Standard Value 0.4-0.5 Nm (3-4 inch lbs)*2
With Oil Seal
New Bearing
Standard Value 1.0-1.3 Nm (9-11 inch lbs)*1
New or Reuse Bearing
Standard Value 0.5-0.6 Nm (4-5 inch lbs)*2

Rear Axle Total Backlash
Limit 5 mm (0.2 inch)

Wheel Bearing End Play
Limit 0.05 mm (0.002 inch)

Wheel Bearing Breakaway Torque
Limit 1.0 Nm (9 inch lbs) or less

Drive Gear Runout
Limit 0.05 mm (0.002 inch)

Note:
*1: When replacing with a new bearing (with rust-prevention oil)
*2: When using a new bearing or when reusing (gear oil application)