Transmission Speed Sensor: Testing and Inspection

PULSE GENERATOR A CHECK
1. Disconnect the pulse generator A connector





2. Measure the resistance between the pulse generator A side connector terminals 1 and 2.
Standard value: 330-390 Ohms [at 20°C (68°F)]
3. If the resistance is outside the standard value, replace the pulse generator assembly.

PULSE GENERATOR B CHECK
1. Disconnect the pulse generator B connector.





2. Measure the resistance between the pulse generator B side connector terminals 3 and 4.
Standard value: 330-390 Ohms [at 20°C (68°F)]
3. If the resistance is outside the standard value, replace the pulse generator assembly.