Radiator Cap: Testing and Inspection

Radiator Cap Valve Opening Pressure Check





1. Use a cap adapter to attach the radiator cap to the tester.
2. Increase the pressure until the indicator of the gauge stops moving.
Standard value:
<2.0L Engine (Non-turbo)> 94 - 122 kPa (14 - 18 psi)
<2.0L Engine (Turbo) and 2.4L Engine> 75 - 105 kPa (11 - 15 psi)
Limit:
<2.0L Engine (Turbo) and 2.4L Engine> 65 kPa (9.2 psi)
3. Replace the radiator cap if the reading does not remain at or above the limit.

NOTE: Be sure that the radiator cap is clean before testing, since rust or other foreign material on the radiator cap seal may cause an improper reading.