Rear Disc Brake

REAR BRAKE DISC THICKNESS CHECK
1. Remove dirt and rust from brake disc surface.





2. Measure disc thickness at 4 locations or more.
Standard value: 10 mm (0.39 inch)
Limit: 8.4 mm (0.33 inch)
Replace the discs and pad assembly for both sides left and right of the vehicle if they are worn beyond the specified limit.

REAR BRAKE DISC RUN-OUT CHECK
1. Remove the caliper support, raise the caliper assembly, and secure it by using a wire, etc.





2. Place a dial gauge approximately 5 mm (0.2 inch) from the outer circumference of the brake disc, and measure the run-out of the disc.
Limit: 0.08 mm (0.0031 inch)

NOTE: To secure the disc to the hub, tighten the nuts.