Rear

REAR BRAKE DISC RUN-OUT CORRECTION
1. If the run-out of the brake disc is equivalent to or exceeds the limit specification, change the phase of the disc and hub, and then measure the run-out again

NOTE: The procedures for checking and changing the rear disc phase are the same as those for the front brake discs. However, the play (limit value) in the hub axial direction is different.

Limit: 0.05 mm (0.0020 inch)
2. If the problem cannot be corrected by changing the phase of the brake disc, replace the disc or turn rotor using an on the car type brake lathe. Be sure to follow the exact brake lathe manufacturer instructions. Rotors turned on the vehicle will often have a lower run-out than a new brake disc.