Front Cross-Member: Service and Repair

REMOVAL AND INSTALLATION

Removal Service Point
[A] Centermember Assembly Removal





1. Set the special tool to the vehicle to support the engine assembly.
2. Remove the centermember assembly.

Installation Service Point
]A[ Front Roll Stopper Bracket Assembly Installation





If the dimension shown in the illustration is outside the standard value when the weight of the engine is on the body, replace the front roll stopper bracket assembly.
Standard value (A): 43 ± 3 mm (1.69 ± 0.12 inch)

INSPECTION
- Check each insulator for cracks or damage.
- Check each bracket for deformation or damage.