Front Cross-Member Bushing: Service and Repair

REMOVAL AND INSTALLATION

Crossmember Bushing Replacement
Crossmember Bushing A And B





1. Apply soapy water to the contact surface of the bush when press-fitting the bush.





2. The bush should be press-fitted so that the inner pipe projection is at the standard length.
Standard values Bushing
A: 9.0 ± 1.0 mm (0.35 ± 0.04 inch)
Bushing B: 4.0 ± 1.0 mm (0.16 ± 0.04 inch)

Crossmember Bushing C





1. Use the special tool to drive out and press-fit the crossmember bushing C.





2. The bushing should be press-fitted so that the inner pipe projection is at the standard length.
Standard value (A): 4.0 ± 0.5 mm (0.16 ± 0.02 inch)

INSPECTION
- Check the crossmember for cracks or deformation.
- Check the bushings for cracks or deterioration.