Transmission Speed Sensor: Testing and Inspection

PULSE GENERATOR A CHECK





1. Disconnect the pulse generator A connector
2. Measure the resistance between the pulse generator A side connector terminals 1 and 2.

Standard value: 330 - 390 [at 20°C (68°F)]

3. If the resistance is outside the standard value, replace the pulse generator assembly.

PULSE GENERATOR B CHECK





1. Disconnect the pulse generator B connector.
2. Measure the resistance between the pulse generator B side connector terminals 3 and 4.

Standard value: 330-390 [at 20°C (68°F)]

3. If the resistance is outside the standard value, replace the pulse generator assembly.