Replacement

Generator - Removal And Installation:

Pre-Removal Operation
Under Cover Side Panel Removal (Refer to Under Cover.)

Post-Installation Operation
- Drive Belt Tension Adjustment (Refer to Maintenance Service.)
- Under Cover Side Panel Installation (Refer to Under Cover.)

Removal
To remove follow the steps listed in the image and note the following:




Step 3: Generator Removal
1. Remove the mounting bolt of the power steering oil pump, and hold the oil pump above the engine mount bracket. Use shop towel, etc. to prevent scarring or scratching of the rocker cover


NOTE: Do not disconnect the oil pump hose.





2. With the generator facing as shown in the figure, remove upward.


Installation
To install reverse the steps listed in the image.