Replacement

Generator - Removal And Installation:

Post Installation Operation
- Under Cover Side Panel Removal
- Speed Control Assembly Removal
(Refer to - Auto-Cruise Control System)

Post Installation Operation
- Speed Control Assembly Installation
(Refer to - Auto-Cruise Control System)
- Drive Belt Tension Adjustment
(Refer to Maintenance Service)
- Under Cover Side Panel Installation
(Refer to - Under Cover.)

Removal
To remove follow the steps listed in the image and note the following :

Step 3: Generator Removal
1. Remove the mounting bolt of the power steering oil pump, and hold the oil pump above the engine mount bracket. Use shop towel, etc. to prevent scarring or scratching of the rocker cover.

NOTE: Do not disconnect the oil pump hose.

2. With the generator facing as shown in the figure, remove upward.

Installation
To install reverse the steps listed in the image.