Brake Lining Thickness Check

1. Remove the brake drum.
2. Measure the wear of the brake lining at the place worn the most. The limit value is 1.0 mm (0.39 inches)
3. Replace the shoe and lining assembly if brake lining thickness is less than the limit or if it is not worn evenly.

CAUTION:
- Whenever the shoe and lining assembly is replaced, replace both RH and LH assemblies as a set to prevent the car from pulling to one side when braking.
- If there is a significant difference in the thickness of the shoe and lining assemblies on the left and right sides, check the sliding condition of the piston.