Valve Body: Service and Repair

Part 1 Of 3:

Part 2 Of 3:

Part 3 Of 3:

DISASSEMBLY
Follow disassembly steps outlined in illustration.

ASSEMBLY
Assembly in reverse order as Disassembly.

NOTE: Assembly service points as follows:





A. Stopper plate / N-D plate / teflon ball / steel ball location. (18, 19, 20, 34 & 43)
1. Install the stopper plates, N-D plate, Teflon ball, and steel balls into the upper valve; body as shown.





B. Upper valve body sub assembly installation. (17)
1. Install the special tool and secure the upper separating plate and intermediate plate with eight mounting bolts. Then, remove the special tool.





C. Oil filter / steel ball / relief spring installation. (14, 15 & 16)
1. Install the oil filter, two steel balls, and spring to the intermediate plate.
D. Lower valve body sub assembly installation. (10)





1. Mount the special tool to the intermediate plate.





2. Install the separating plate.





3. Secure the lower valve body with mounting bolts and then remove the special tool.





E. Solenoid valve assembly installation. (2, 3, 4 & 5)
1. Install the solenoid valves as shown.
Solenoid valve:
Shift Control Solenoid Valve A (SCSV-A): (Wire color) Orange.
Shift Control Solenoid Valve B (SCSV-B): (Wire color) Yellow.
Torque Converter Clutch (TCC) solenoid: (Wire color) Red or Red/Black.
Pressure Control Solenoid Valve (PCSV): (Wire color) Blue.