Intake Manifold

INTAKE MANIFOLD






Removal
Follow removal steps outlined in illustration.

Installation
Installation in reverse order as removal.

Installation Service Points





]A[ Sealant Application To Thermostat Housing.

Specified sealant:
Mitsubishi Genuine Part No. MD970389 or equivalent

NOTE:
1. Be sure to install the housing quickly while the sealant is wet (within 15 minutes).
2. After installation, keep the sealed area away from the oil and coolant for approximately one hour.





]B[ Sealant Application To Water Outlet Fitting.

Specified sealant:
Mitsubishi Genuine Part No. MD970389 or equivalent

NOTE:
1. Be sure to install the housing quickly while the sealant is wet (within 15 minutes).
2. After installation, keep the sealed area away from the oil and coolant for approximately one hour.





]C[ Sealant Application To Engine Coolant
Temperature Sensor.

Specified sealant:
3M Nut Locking Part No. 4171 or equivalent





]D[ Sealant Application To Engine Coolant Temperature Gauge Unit.

Specified sealant:
3M ATD Part No. 8660 or equivalent