Fuel and Emission Control Parts

FUEL AND EMISSION CONTROL PARTS






Removal
Follow removal steps outlined in illustration.

Installation
Installation in reverse order as removal.

Installation Service Points





]A[ Injectors / Injector Clip Installation.
1. Before installing an injector, the rubber O-ring must be lubricated with a drop of clean engine oil to aid in installation.
2. Install injector top end into fuel rail. Be careful not to damage O-ring during installation.

]B[ Fuel Pressure Regulator Installation.
Before installing the pressure regulator, the O-ring must be lubricated with a drop of clean engine oil to aid in installations.