With Manual Transmission/Transaxle

REMOVAL
1. Remove the transaxle.
2. Remove the clutch cover and clutch disc.
3. Refer to the illustration for the remaining removal steps, noting the following:





4. Use flywheel stopper tool No. MD998781, or equivalent, to secure the flywheel and remove the bolt.

INSTALLATION
1. Apply a small amount of engine oil to the entire inside diameter of the rear oil seal lip.





2. Tap in the oil seal using crankshaft rear oil seal installer tool No. MD998776 and handle No. MB990938, or equivalents, as shown.





3. Clean off all sealant, oil and other substances which are adhering to the threaded bolts, crankshaft thread holes and the flywheel.
4. Apply oil to the bearing surface of the flywheel.
5. Apply oil to the crankshaft thread holes.
6. Apply 3M Stud Locking Sealant No. 4170, or equivalent, to the threaded mounting bolts.





7. Use the flywheel stopper to secure the flywheel, and then tighten the bolts 127 - 137 Nm (94 - 101 ft. lbs.).