D. Replacing the PCM

NOTE:
ONLY vehicles equipped with a non-programmable PCM, as determined by the inspection procedures in Section C, require a PCM replacement.

1. Make sure the negative (-) battery cable is disconnected from the battery.

NOTE:
Remember to record all radio settings before disconnecting the battery and to reset the stations and the clock when servicing is finished.





2. Disconnect the PCM electrical connector.

3. Remove the bolts that attach the PCM mounting bracket to the inner fender and then remove the PCM and bracket assembly.

4. Remove the PCM from the mounting bracket. Discard the PCM.

5. Install the new PCM on the mounting bracket and tighten the bolts securely.

6. Install the new PCM and bracket assembly on the inner fender and tighten the bolts securely.

7. Connect the PCM electrical connector.

8. Connect the negative battery cable. Reprogram the radio and the clock.