Model F4AC1

1. Drain fluid and remove oil pan and filter assembly.
2. Remove oil temperature sensor.
3. Press solenoid valve harness grommet and connector into transaxle case.
4. Remove valve body assembly. Use care not to drop manual valve.

Fig. 21 Valve Body O-Ring Position:

5. Ensure O-ring is installed on upper surface of valve body as shown, Fig. 21.
6. Install new solenoid valve harness grommet O-ring.
7. Install harness grommet into case.
8. Install valve body and oil temperature sensor.
9. Install oil filter, new oil pan gasket, oil pan and ATF.
10. Ensure transaxle oil pressure is correct. Readjust as necessary.