DTC 31

1. Turn the ignition key to the "LOCK" position, disconnect the negative battery cable and tape the terminal.

Caution: Wait at least 60 seconds after disconnecting the battery cable before doing any further work.

2. Remove the floor console assembly.





3. Place a flat-tipped screwdriver against the lock spring at the lock lever notch and push the spring toward the unit.

Caution: Do not use excessive force to raise the lock lever (green).

The capacitor inside the SDU is probably defective, so replace the SDU.
However, code No.32 could also be a result of a short in the front impact sensor, so inspection of the front impact sensor system should also be carried out.