Shift Cable: Service and Repair

REMOVAL
1. Remove the console box assembly.
2. Remove the selector knob installation screws.
3. Disconnect the overdrive switch connector and then remove the selector knob.




4. Remove the cover, indicator panel, slider.
5. Disconnect the position indicator connector and normal/economy select switch connector




6. Remove the pin, self lock pin from the link.




7. Remove the clip, nut from the shift lever side.




8. Remove the bolt-washer assembly located on dash panel.




9. Remove the clip, flange nut from the transaxle side.
10. Remove the transaxle control cable assembly.




INSTALLATION
1. Apply a coating of the specified grease to the interior of the adjust bushing.

Specified grease:
Chassis grease SAE J310, NLGI No.0




2. Move the shift lever and the transaxle range switch to the "N" position, and install the transaxle control cable.




3. When connecting the control cable to the transaxle mounting bracket, install the clip until it contacts the control cable, in position switch in the figure.




4. Install the bolt-washer assembly, nut.




5. Install the clip pin, self lock pin (shift lever side).




6. Connect the position indicator light connector, the O/D switch connector, the parking position switch connector, normal/economy select switch connector and the shift lock solenoid connector.
7. Install the shift lever indicator assembly.




8. Apply the specified grease at the places shown.

Specified grease:
Multipurpose grease SAE J310 NLGI No.2




9. Place the shift lever in the "N" position, and then turn the cam rod adjusting so that the clearance between the sleeve and the lever assembly end is within the standard value.

Standard value (A):
15.2-15.9 mm (0.598-0.625 in.)

10. Install the selector knob.
11. Install the console box.