Throttle Cable/Linkage: Service and Repair

PROCEDURE

Removal

1. Remove the two bolts and remove the inner cable at the accelerator arm side.





2. Loosen the bolts holding the accelerator arm bracket and remove the bracket.
3. Remove the Accelerator Cable from the Throttle Body and remove the Accelerator cable assembly.

Installation





1. When installing the return spring and accelerator arm, apply multi-purpose grease around each moving point of the accelerator arm.





2. Apply sealant to the bolt mounting hole, and tighten the accelerator arm bracket.

Tightening torque: 8 - 12 Nm (5.8 - 7.2 lb ft)

Accelerator Cable, Pedal End Grease Point:

3. Securely install the resin bushing of the accelerator cable on the end of the accelerator arm.
4. Apply multipurpose grease around the cable end.
5. Attach and secure the Accelerator Cable end to the Throttle Body.