Rear Crankshaft Main Bearing Seal: Service and Repair

1. Remove transmission, clutch assembly and flywheel or flex plate, as equipped.

Fig. 16 Disassembled View Of Oil Seal Case & Separator:

2. Remove rear oil seal case and separate: oil seal, case and separator, if equipped. Fig. 16.

Fig. 17 Rear Seal Installation:

3. Drive in oil seal from inside of case, Fig. 17. Ensure oil seal plate fits properly in inner contact surface of seal case, if equipped.
4. Install separator with oil hole facing bottom of case, if equipped.
5. Apply engine oil to oil seal lips.
6. Install oil seal case in cylinder block.