SRS Diagnostic Procedures - Initial Steps
SRS DIAGNOSTIC PROCEDURES - INITIAL STEPSFollow These Steps When Beginning Any SRS Service:
1. Check the SRS fuses (multi-purpose fuses No.11 and No.18). If either is loose, tighten it; if damaged or blown, replace it.
2. After performing step 1, start engine. Does "SRS" warning light illuminate for about 7 seconds and then turn OFF? If yes, SRS system is functioning properly. If no, continue with following steps.
NOTE: The SRS warning light will light even when the battery voltage drops. In this case, the SRS warning light will go out when the battery voltage is restored to the normal value.