Horizontal Adjustment

Horizontal Adjusting:

1. Insert a screwdriver in the horizontal adjusting hole and turn it until the "0" mark and the centerline of stopper are in alignment.
2. Confirm that the beam irradiated on the screen is the same as the specified beam pattern. If it is not the same, adjust the beam with the following steps.
a. Insert a screwdriver into the horizontal adjusting hole, and adjust the horizontal angle so that the specified beam pattern is obtained.
b. Lift up the stopper, and push gear (B) in the direction of the arrow to release the fitting with gear (A).
c. Align the "0" mark on gear (B) with the center line of the stopper.
d. Press in the stopper, and align the gear (B) and gear (A) fitting.