AWD Models

Fig. 25 Replacing Trailing Arm. Eclipse AWD Models:

Fig. 26 Replacing Trailing Arm. 3000GT AWD Models:

Fig. 27 Replacing Trailing Arm Connecting Rod:

Fig. 28 Installing Trailing Arm Connecting Rod:

1. Remove trailing arm in numbered sequence shown in Figs. 25 and 26, noting the following:
a. Using end yoke holder tool No. MB990767-01, secure rear axle shaft then remove self locking nut.
b. Using axle puller and slide hammer tool Nos. MB990211-01 and MB990241-01 or equivalent, remove rear axle hub.
c. Using ball joint remover tool No. MB991113-01 or equivalent, loosen and disconnect ball joint from knuckle. Loosen do not remove ball joint nut.
2. Replace connecting rod as follows:
a. Remove trailing arm bushing.
b. Remove connecting rod nut and bolt.
c. Install rod remover and installer tool No. MB9911254 or equivalent, as shown in Fig. 27.
d. Apply lubricant to sliding points (marked A). Install bolt (B) in trailing arm.
e. Using a suitable wrench, turn screw (C) to remove connecting rod.
f. Installation of body of special tool should be performed with screw shaft and guide shaft center lines oriented as shown in Fig. 28.
g. Apply soapy water to rubber portion of connecting rod then reverse procedure to install.
3. Reverse procedure to install.