Models W/Sumitomo Caliper

Fig. 9 Exploded view of disc brake assembly w/Sumitomo caliper:

1. Raise and support vehicle, then remove wheel/tire assembly.
2. Remove pad protector by prying upward at center with screwdriver or equivalent tool.
3. Remove M-clip and K-spring from pad retaining pins, Fig. 9.
4. Remove brake pad retaining pins from caliper, then pull brake pads from caliper assembly and remove anti-squeak shim from outer pad.
5. Bottom piston in caliper using suitable tool.
6. Install anti-squeak shim onto outer pad, then install pads and retaining pins into caliper.
7. Install M-clip and K-spring onto retaining pins, then place pad protector into position on retaining pins.