51 31 000 Removing and Installing/Renewing Windscreen

51 31 000 Removing And Installing/Renewing Windscreen







IMPORTANT:
The following notes form the basis for these repair instructions and must be adhered to at all times:
- Notes on window bonding
- General procedure for dismantling/installation of affixed window glass

NOTE:
- Replacement: Remove using wire pull handles.
- If reusing: Remove using Roll Out 2000.







Necessary preliminary work:
- Remove cover for windscreen cowl panel.
- Remove windscreen rubber surround
- Remove trims for A-pillar on left and right
- If necessary, remove rain/light sensor







Disconnect plug connection (1).
Secure cable with adhesive tape to windscreen.

IMPORTANT: Pay attention to cable when cutting in this area.







Installation note:
If necessary, replace defective expanding foam tape.

Version with visible vehicle identification number:
Stick 60 mm long expanding foam tape 5 mm above viewing window for VIN onto ceramic layer of windscreen.







Fitting 3 spacer buffers (spacers):

IMPORTANT:
- To avoid windscreen breakage and wind noises:
- Completely remove remnants of removed spacer buffers (1) and maintain installation position exactly.

Stick semicircular spacer buffers (1) onto body flange.

Overview of windscreen bonding:







If necessary, fit new retaining strip (5) and rubber frame (6), paying attention to centre marks in the process.
Insert positioner (7) for retaining strip (5) must be removed after it has been fitted on the windscreen but before the windscreen itself is installed.







Perform the following steps carefully on the windscreen (1) using suction cup (51 3 010):
- Position at top
- Align sides evenly
- Insert at bottom and press down
- press upwards until sealing rests evenly on roof
- secure in terms of height in this position at top with two yellow plastic adhesive tapes (2)