51 14 002 Removing and Installing/Replacing Front Mini Badge

51 14 002 Removing and installing/replacing front MINI badge

Special tools required:







IMPORTANT: The Instructions on component cementing with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail.

NOTE: The MINI badge is damaged when removed and must be replaced.







Removing badge:
Heat MINI badge (1) with hot air blower and carefully lever out with special tool 00 9 322.







Fitting badge:
Pull liner* off adhesive tape (1), position badge over guide pins (2) on hood/bonnet and press down firmly.
* Liner is the protective film on a new plate.