65 83 580 Removing and Installing/Replacing DVD Drive For Car Communication Computer (CCC)

65 83 580 Removing and installing/replacing DVD drive for Car Communication Computer

Special tools required:







IMPORTANT:
Read and comply with notes on protection against electrostatic discharge (ESD protection).
Risk of damage.
Place Car Communication Computer on special tool 12 7 192 (antistatic mat) and connect to earth/ground.







Necessary preliminary work:
- Remove front trim panel for Car Communication Computer







If necessary, cut through warranty seal.
Raise lid (1) with special tool 64 1 020 all round and remove from Car Communication Computer (2).







Release screws (1).
Feed out bridge (2).

Installation note:
Use special tool 00 9 450 to tighten down screws.

Tightening torque 65 11 1AZ. Mechanical Specifications







Cut through labels at marked points (1).
Release screws (2) and remove cover (3).

Installation note:
Use special tool 00 9 450 to tighten down screws.

Tightening torque 65 11 1AZ. Mechanical Specifications







Release screws (1) with magnetic screwdriver.

Installation note:
Tab (2) of DVD drive must be above tab (3) of Car Communication Computer.







Turn Car Communication Computer through 180° and carefully feed out DVD drive.

Carefully disconnect plug connections (1, 2).
Remove DVD drive (3).

Installation note:
Ensure correct cable routing.







NOTE:
There are two versions of the plug connection (2) shown in image R65 0952:
Previous version (1): ribbon cable is connected horizontally
Current version (2): ribbon cable is connected vertically







After installation:
On cars before March 2006 it is essential after replacing the DVD drive to carry out an action plan or a software update as per SSS/Progman/CIP.