34 52 535 Replacing A Rear Pulse Generator

34 52 535 - Replacing a rear pulse generator





Necessary preliminary tasks:
- Partially detach rear underbody panelling





Release cable from retaining clip on rear axle carrier (1).
Disengage cable from holder (1) at shock absorber.
Release screw (2) and remove pulse generator (3).

Installation:
Tightening torque 34 51 4AZ 34 51 Traction Control System (ABS, ASC+T, DSC).
Clean bore hole for pulse generator and grease with Staburags NBU 12/K lubricating grease (refer to BMW Service Operating Fluids).





Unclip cable from retainers (1).
Disconnect plug connection (2).

Installation:
Make sure plug connection engages correctly.