13 62 618 Replacing Temperature and Boost Pressure Sensor

13 62 618 - Replacing temperature and boost pressure sensor (N14)





Important!
Read and comply with notes on protection against electrostatic damage (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).





Unlock plug (1) and remove.
Release screw and detach sensor (2) from charge air duct.

Installation Note:
- Check sealing ring for damage, replace if necessary.
- When installing, coat sealing ring with suitable antiseize agent.
- Tightening torque 13 62 6AZ 13 62 Senders for Control Unit.





Check stored fault messages.
Now clear the fault memory.