Transmission Position Sensor/Switch: Service and Repair

24 10 006 Removing and installing/replacing gear position switch (AISIN)

Special tools required:







IMPORTANT:
An incorrectly adjusted gearshift mechanism can result in gear tooth meshing noises being transmitted to the passenger compartment.
Adjust selector lever.







Necessary preliminary tasks:
- Remove gaiter for intake silencer housing
- Drain coolant
- Remove intake silencer housing
- Remove coolant expansion tank







Detach wiring harness (1) from bracket (2) and pull up.
Release spring band clamp (3) on coolant hose with special tool 17 2 051.
Remove coolant hose.







Unfasten plug connection (1) from transmission position sensor and disconnect.
Release nut (2) and remove selector lever (3).
Tightening torque 24 11 6AZ.







Release washer (1), lock washer (2) and nut (3).
Release screws (4).
Remove switch.

Installation note:
Insert screws (4) slightly.
Fit washer, lock washer and nut.
Tightening torque 24 11 12AZ.







Mount special tool 24 4 270.
Tighten screw (1).
Align gear position switch to "N".
Tighten down screws (2).
Tightening torque 24 11 12AZ.

Installation note:
Connect gear position switch connector

o��: