Keyless Start Antenna: Service and Repair

66 12 100 Removing and installing/replacing slide-in unit for radio-operated key







Necessary preliminary tasks:
- Remove lower left trim from instrument panel







IMPORTANT:
In the event of complaint "slide-in unit for radio-operated key jams or can not be retained", carry out following checks before replacement:
1. Check both sides of plug connection of ribbon cable (1) to slide-in unit for radio-operated key (4) for correct locking (3).
2. Check ribbon cable (2) for damage.
If required, lock plug connection of ribbon cable (1) correctly and carry out function check.
If this rectifies fault pattern, do not replace slide-in unit for radio-operated key.







Release screws (1).
Release clips at marked points.
Remove slide-in unit for radio-operated key (2).







Installation note:
Make sure clasps (1) are correctly seated, replace if necessary.