Removing and Installing/Replacing Positioning Motor for Eccentric Shaft

11 37 020 Removing And Installing/Replacing Positioning Motor For Eccentric Shaft (N16)







Necessary preliminary tasks:
- Remove acoustic cover.







Disconnect plug connection (2) on servodrive.
Pull off engine wiring harness at retaining clip (1) from servodrive.







Release screws (1).
Tightening torque: 11 37 4AZ.

Installation note:
Replace gasket.







IMPORTANT: Risk of damage to intermediate shaft.

Turn screwdriver (1) counterclockwise in direction of arrow and relieve tension on intermediate shaft.

NOTE: Do not rotate shaft too far (maximum / end stop).

Remove servodrive.

Installation note:
Insert servodrive with screwdriver (2).







Assemble engine.
Check function of Digital Engine Electronics.