P1339

296D - P1339

Information saved in
DME

Fault code
296D - P1339

Fault text
Exhaust camshaft sensor

Fault description
Exhaust camshaft sensor

Condition for fault identification
Test condition:
Engine speed 1240 .. 3000 rpm
Engine charge density 0 .. 20 %
Terminal condition: Terminal 15
Voltage condition:
none

Condition for fault memory entry
255 crankshaft revolutions

Action in service
1. Check sensor installation (gap to reluctor ring is too
large/small, specified gap is 0.1 to 2.0 mm)
Inspect to verify that the camshaft position sensor is
correctly installed and that the bolt is not loose. Torque
specification is 1.5 - 2 Nm
The sensor must be installed at a right angle above the
camshaft reluctor ring.
Inspect the O-ring and replace if damaged or missing.
2. Check reluctor for correct installation and for damage
3. Check alignment (timing adjustment) of cam reluctors
4. Check timing chain and tensioner.

Fault effect and breakdown warning
The engine reverts to its emergency limp-home program,
continued vehicle operation is possible, because power is
reduced the driver should refrain from passing maneuvers.
Long starting periods, loss of power

Driver information
Warning light:
MIL ON

Service instruction
None