Transmission Cooler: Service and Repair

24 11 040 Removing and installing/replacing transmission oil cooler (AISIN)







IMPORTANT:
After completion of work, check gearbox oil level.
Use only the approved transmission oil.

Failure to comply with this requirement will result in serious damage to the automatic transmission.

IMPORTANT: No dirt is allowed to enter the oil circuit.

Failure to comply with this requirement will result in serious damage to the automatic transmission.







Necessary preliminary work:
- Drain coolant
- Remove intake silencer housing
- Remove intake silencer housing gaiter.







Unfasten hose clamps.
Detach coolant hoses (1) from transmission oil cooler.







Release screw (1).
Tightening torque 24 11 11AZ.

Installation note:
Pay attention to position lug (2).







Replace sealing ring (1).

Installation note:
Clean contact surfaces.
Moisten sealing ring (1) with clean transmission oil.







Replace sealing ring (1).

Installation note:
Clean contact surfaces.
Moisten sealing ring (1) with clean transmission oil.

׉�: