Throttle Body: Service and Repair

13 54 030 Removing and installing/sealing the throttle body (N12, N16)







Necessary preliminary work:
- Read out fault memory of DME control unit.
- Check stored fault messages.
- Switch off ignition.
- Remove the air intake hose.







Release screws.
Tightening torque 13 54 1AZ .
Carefully feed out throttle body (1) toward the top until the connector for the cable connection is accessible.
Unlock connector and remove.
Remove throttle body (1).







Installation note:
Replace sealing ring (1).







NOTE:
Check stored fault messages.
Delete fault memory.