Removing and Installing/Replacing Positioning Motor for Eccentric Shaft

11 37 020 - Removing and installing/replacing positioning motor for eccentric shaft (N12)





Necessary preliminary tasks:
- Remove acoustic cover.





Disconnect plug connection (2) on servodrive.
Pull off engine wiring harness at retaining clip (1) from servodrive.





Release screws (1).
Tightening torque: 11 37 4AZ Mechanical Specifications.

Installation:
Replace seal.





Important!
Risk of damage to intermediate shaft.

Turn screwdriver (1) counterclockwise in direction of arrow and relieve tension on intermediate shaft.

Note:
Do not rotate shaft too far up to maximum to end stop.

Remove servodrive.

Installation:
Insert servodrive with screwdriver (2).





Assemble engine.
Check function of DME.