32 31 090 Removing and Installing/Replacing Steering Column

32 31 090 Removing and installing/replacing steering column







Necessary preliminary tasks:
- Remove lower section of steering column trim
- Remove revcounter







IMPORTANT:
If the steering spindle is separated from the steering gear, this can result in damage to the steering-column switch cluster when the steering wheel is turned.
Lock steering spindle with steering lock.

Release screw (1).
Detach lower section of steering spindle (2) from steering gear and swing towards rear.

Installation:
Clean thread to remove all remnants of screw securing adhesive.
Replace screw.
Tightening torque 32 31 2AZ.







Disconnect plug connections (1) on steering-column switch cluster.







Disconnect plug connection (1).
Release screws (2) and remove steering column towards rear.

Installation:
Replace screws.
Tightening torque 32 31 3AZ.







Replacement:
- Modify steering-column switch cluster







After installation:
- Version with Dynamic Stability Control (DSC): Carry out steering angle sensor adjustment

NOTE: Only cars with DSC are fitted with a steering angle sensor (integrated in the steering-column switch cluster).