Securing Engine In Installation Position

11 00 670 Secure Engine In Installation Position (N12, N14, N16, N18 N47)

Special tools required:







WARNING:
Danger of injury.
Observe following instructions relating to special tool:
1. Prior to each use, check the special tools for defects, modifications and operational reliability.
2. Damaged/modified special tools must not be used.
3. No changes or modifications may be made to the special tools.
4. Keep special tools dry, clean and free of grease.







Assemble cross-member 00 0 200 with special tools 00 0 202, 00 0 204, 00 0 208.

Modification:
Remove front supports (1).







Attach special tool 00 0 490 on left and right to cross-member 00 0 200.







IMPORTANT: Do not damage Bowden cable (1).

With a 2nd person helping, place cross-member 00 0 200 on spring strut dome and secure special tool 00 0 490 with knurled screws (2) on engine support.







IMPORTANT:
Avoid a change of engine position in the transverse or longitudinal direction.
Always make sure there is sufficient clearance between the engine (or its add-on parts) and the body.







Align cross-member 00 0 200 so that spindle 00 0 202 is correctly positioned over suspension lug.
Secure suitable chain to spindle 00 0 200 and attach to suspension lug (1).







WARNING:
Danger of injury.
Tighten down all adjusting screws, knurled screws and nuts on cross-member 00 0 200 and on special tool 00 0 490.







IMPORTANT: Complete the following tasks without fail before raising the engine.







Left side only:
Remove transmission support bracket







Right side only:
Slacken nut (1).

Installation note:
Replace self-locking nut.
Tightening torque 22 11 2AZ.







IMPORTANT:
Avoid overelongation of rubber mounts in bracket (1) when raising.
Slacken screws (2) and (3).

Installation note:
Secure engine first to engine or transmission mounts and then tighten down bolts (2) and (3).
Tightening torque 22 11 6AZ.