Body - One-Touch Window feature Inop. After FRM R and I
SI M51 02 08Body Equipment
February 2009
Technical Service
This Service Information bulletin supersedes SI M51 02 08 dated April 2008.
[NEW] designates changes to this revision
SUBJECT
[NEW] One-Touch Window Function Inactive After FRM Replacement
MODEL
R55 (Cooper Clubman, Cooper S Clubman)
R56 (Cooper, Cooper S)
SITUATION
After replacement of the FRM (Footwell Module) or after vehicle programming, the one-touch window control and anti-trap function on the front side windows is inactive.
CAUSE
FRM/power window regulator
PROCEDURE
Do not replace any parts.
[NEW] Reinitialize the power windows via the initialization test plan in ISTA. This test plan may be found under Service Functions/Body/Locking and Security/Power Windows/Initialize Power Window.
[NEW] As an alternative, the windows may be initialized manually, using the following procedure:
[NEW] Note:
This procedure replaces that in repair instruction 67 62..., which will be updated. The procedure shown in the repair manual is for vehicles without the one-touch window control.
1. Close the window and door fully.
2. Lower the window by holding the switch in the "down" position. Continue to hold the switch down for at least 5 seconds after the window has been fully lowered.
3. Raise the window by holding the switch in the "fully up" position. Continue to hold the switch in the up position for at least 5 seconds after the window has been fully raised.
4. Repeat steps 1 to 3 for the window on the other side.
WARRANTY INFORMATION