25 16 056 Removing and Installing/Replacing Shift Tower (AISIN)

25 16 056 Removing and installing/replacing shift tower (AISIN)

Necessary preliminary tasks:
^ Move selector lever into "P" position.
^ Remove suction filter housing.
^ Remove exhaust system.
^ Remove intake filter housing boot.
^ Remove heat shield.
^ Remove cable from holder on floor plate.





Slide locking sleeve for cable (3) in direction of arrow.

Remove cable from holder.





Release cable lock nut (1).

Remove cable from holder (2).

Tighten AISIN shift cable to clamping piece
M8 12 Nm

Installation:
Adjust selector lever.





Remove retaining screws (1) of gear shift housing.

Tighten shift housing to body 8 Nm

Note:
Illustration similar.





Press shift bracket (1) in direction of arrow.
Fold shift bracket downwards.
Disconnect plug connection (1) and remove shift bracket.





Important!
An incorrectly adjusted gearshift mechanism can result in gear teeth noises being transmitted to the passenger compartment.

Installation:
Adjust selector lever.

Installation:
Move selector lever to "P" position.

Check whether parking lock is engaged by turning output shaft.