Carpet: Service and Repair

51 47 450 - Removing and installing/replacing complete carpet





Necessary preliminary tasks:
- Remove left/right front seat Removing and Installing Left or Right Front Seat (Normal/Manual)
- Remove rear seat
- Remove front storage compartment 51 16 200 Removing And Installing Front Center Console
- Remove rear storage compartment holder Removing and Installing / Replacing Rear Storage Compartment Holder
- Remove rear left/right side trim Removing and Installing Rear Left or Right Side Trim Panel
- Remove inside entrance cover strip 51 47 000 Removing and Installing/Replacing Front Left or Right Entrance Cover Strip
- Remove adapter plate Replacing Adapter Plate





Release screws (1).
Remove cover (2).





Unscrew nuts (1).
Feed cable (2) out of console (3) and remove console (3).
Release screw (5) and remove storage tray (4).





Slide connecting piece (1) upwards up to stop.





Remove carpet (1) first at rear towards top.
Pull back carpet (1) at front under heater (2).

Note:
A cut (3) is already provided in carpet (1).
Pay attention to cable when removing carpet (1).
If necessary, cut carpet (1) to feed out cable.

Installation:
Make sure openings for air duct and attachment points are correctly positioned.