Removing and Installing/Replacing Cable For Front Engine Hood Locks (With Storage Compartment)

51 23 211 - Removing and installing/replacing cable for front engine hood locks (with storage compartment)





Necessary preliminary tasks:
- Remove grille for air inlet/heating on left/right
- Remove right entrance cover strip 51 47 000 Removing and Installing/Replacing Front Left or Right Entrance Cover Strip
- Disconnect Bowden cable from hood/bonnet lock
W11 engine:
- Remove intake filter housing
W10 and W17 engines:
- Remove battery cover
Version with storage compartment:
- Remove right glovebox
Version with glovebox:
- Remove right glovebox 51 16 360 Removing and Installing Right Glove Box





Disconnect Bowden cables (2) from release lever (1).

Installation:
Lay Bowden cables (2) without kinks and correctly through bore (3).





Disconnect Bowden cable (2) on left/right from holders (1).
Feed Bowden cable (2) on left out of bore (3).

Installation:
Lay Bowden cable (2) without kinks.





Bowden cable for left hood/bonnet lock, left side:

Note:
For purposes of clarity, illustration shows brake booster removed.

Disconnect Bowden cable (1) from holder (2).

Installation:
Lay Bowden cable (1) without kinks.

3 - Bore





Bowden cable for left hood/bonnet lock, right side:
Unscrew nuts (1).
Carefully pull bulkhead cover (2) forwards.





Note:
For purposes of clarity, illustration shows bulkhead cover removed.

Disconnect Bowden cable (1) from holder (2).

Installation:
Lay Bowden cable (1) without kinks.

3 - Bore





Feed Bowden cable (2) out of bore (3).
Feed Bowden cables (1 and 2) out of bore (4).

Installation:
Lay Bowden cables (1 and 2) without kinks.