Campaign - Real Time Traffic Information Programming

SI M65 03 08
Audio, Navigation, Monitors, Alarms, SRS

February 2008
Technical Service

PERFORM THE PROCEDURE OUTLINED IN THIS SERVICE INFORMATION ON ALL
AFFECTED VEHICLES BEFORE CUSTOMER DELIVERY OR THE NEXT TIME THEY
ARE IN THE SHOP FOR MAINTENANCE OR REPAIRS.

SUBJECT
Service Action: Real Time Traffic Information Not Available

MODEL
R55 (Cooper Clubman, Cooper S Clubman) with SA609 Navigation System

R56 (Cooper, Cooper S) with SA609 Navigation System

SITUATION
On certain vehicles, RTTI (Real Time Traffic Information SA6UH) is not available.

CAUSE
RTTI was inadvertently left out of the VO (Vehicle Order).

AFFECTED VEHICLES
This Service Action involves R55 and R56 vehicles which were produced from October 2007.

In order to determine if a specific vehicle is affected by this Service Action, it will be necessary to reference the attached VIN list. If the vehicle is included on the VIN list, check the driver's door jamb
for a service action label code with code number 36 punched out. If code number 36 is already punched out, this service action has already been completed.





The chassis number ranges listed below are only for informational purposes and are not to be considered as the only deciding factor.

PROCEDURE

1. Verify that this vehicle is affected by this service information by checking the attached VIN list.

2. If the VIN number is included on the list, submit a PuMA case with the subject "RTTI missing SI M65 03 08". Also note in the case whether a JCW kit has been installed, so this can be included with the new VO.

3. A modified vehicle order will be attached to the case with instructions on how to download.

4. Start a new Progman session. Select the applicable model and series.

5. Once the session is started, select "Vehicle".

6. Make sure that the disk with the new VO is in the SSS. Select "Adapt VO" and follow the onscreen instructions.

7. After the VO has been adapted, select "Complete encoding" and code the complete vehicle.

8. Note: Other modules may be updated at the same time if the vehicle has an older integration level than Progman.

9. After the encoding is completed, turn the ignition off and let the CCC go to sleep (after 5 minutes).

10. Check the functionality of RTTI.

LABEL INSTRUCTIONS

This Service Action has been assigned code number 36. After the vehicle has been checked and/or corrected, obtain a label (MD20-036) and:

A. Emboss your MINI dealer warranty number in the middle of the label (1);

B. Punch out code number 36 (2), printed on the label; and





C. Affix the label to the B pillar as shown.

If the vehicle already has a label from a previous Service Action/Recall Campaign, affix the new label next to the old one. Do not affix one label on top of another one because a number from an underlying label could appear in the punched-out hole of the new label.

WARRANTY INFORMATION








Covered under the terms of the MINI New Vehicle Limited Warranty.