Removing and Installing Complete Rear Left or Right Power Window Unit

51 37 000 Removing And Installing Complete Rear Left Or Right Power Window Unit

Necessary preliminary tasks:
- Remove rear side trim panel
- Remove inner window cavity cover strip
- Remove outer window cavity cover strip







Release screws (1) and remove connecting bracket (2).

4AZ Connecting bracket to body 8 Nm







Side window (1) must be opened to dimension (A).
A = approx. 150 mm







Slacken nut (1) (do not release fully).

3AZ Power window unit to body 8 Nm







Slacken screws (1) on power window unit (2) (do not release fully).

3AZ Power window unit to body 8 Nm







Pull out power window unit (1) towards top slightly.
Lift out cable holder (2) from power window unit (1).
Disconnect plug connection (3) on flat motor (4).
Remove power window unit (1).







Presettings after fitting power window unit:
Preset dimension (A) at power window unit (1) (window glass breakage); only then may the power window unit (1) be actuated.
Dimension (A) = 18.5 mm







Close window completely.
Check gap dimensions (A and B) between side window (1) and flange on side panel (2) and adjust if necessary.
Dimension (A) = 16 mm
Dimension (B) = 10 mm







Open convertible top and convertible top compartment lid.
Fit window cavity cover (1).
Preset dimension (C) between window cavity cover (1) and flange on side panel (2).
Dimension (C) = 24 mm

Installation:
Check function.
Adjust rear side window.