Removing and Installing Power Steering Pump

32 41 030 - Removing and installing power steering pump





Important!
Adhere to the utmost cleanliness.
Do not allow any dirt to enter the system.
Seal off line connections with plugs.





Necessary preliminary tasks:
- If necessary, remove and install fan for power steering Removing and Installing/Replacing Fan for Power Steering

After completing tasks, bleed power steering Service and Repair





Recycling:
Observe country-specific waste-disposal regulations.

Draw hydraulic fluid out of tank -> do not reuse.





Release plug connector (1) and pull off.

Note:
Disconnect plug connection (2) in straight direction, otherwise damage may be caused.





Release screw (1) and disconnect pressure line.

Installation Note:
Tightening torque 32 41 3AZ Pump and Oil Supply

Remove hose clamp (2) and detach return line.

Installation Note:
Replace hose clip.





Unfasten screws (1).

Installation Note:
Tightening torque 32 41 1AZ Pump and Oil Supply





Slacken nut (1).

Installation Note:
Replace self-locking nuts.
Tightening torque 32 41 2AZ Pump and Oil Supply

Remove power steering pump (2) with bracket.





When replacing power steering pump:
Release nuts (1) on all four rubber mounts.

Installation Note:
Tightening torque 32 41 10AZ Pump and Oil Supply

Release screws (2) and remove rubber mounts (3).

Installation Note:
Tightening torque 32 41 11AZ Pump and Oil Supply

Replace damaged rubber mounts (3).