Removing and Installing Shift Lever Bracket

Removing and Installing Shift Lever Bracket


Necessary Preliminary Tasks:
- Remove shift lever boot, please refer to: Replacing Gaiter on Gearshift Lever
- Remove rear silencer/exhaust system, please refer to: Service and Repair





Undo screws (1) and remove front heat shield.





Tightening Torque.





Undo screws (1) and remove centre heat shield.





Tightening Torque.

Release shift cables from retaining fixtures on vehicle floor.





Release screws (1).

Detach shift lever housing (2).





Caution!
Do not damage locking tabs on cover.

Lift out locking tabs and release shift lever cover.





Installation note:
Locking tabs (1) on cover (2) must not be damaged.
Replace seals if defective.





Use suitable pliers to detach shift cable assemblies (1).

Remove clips (2) and pull shift cable assemblies out of housing.