Wiring Harness: Service and Repair

24 35 508 - Replacing wiring harness in automatic transmission (AISIN)

Important!
After completion of work, check transmission fluid level Service and Repair.
Make a note of drained ATF quantity.
Required replenishment quantity approx. 4.5 liters.

Important!
Use only the approved automatic transmission fluid in this automatic transmission.
Otherwise the automatic transmission may incur extensive damage!
Do not drain fluid before the transmission has cooled down.

Necessary preliminary tasks:
- Remove hydraulic selector unit Service and Repair

Release screw (1).
Disconnect multiple connector (2) of EGS control unit.
Tightening torque: 24 11 19AZ [1][2]Fluid Pan, A/T.

Installation Note:
Coat O-ring with ATF.