Sunroof / Moonroof Interior Trim Panel: Service and Repair

54 12 300 Removing And Installing/Replacing Front (Or Rear) Sliding Sunroof Roller Blind

Necessary preliminary tasks:
- Release roofliner, but do not remove

Note:
Roofliner only needs to be released and does NOT have to be removed from the car.
It is NOT necessary to remove the front seats.







Remove TX20 Torx screws (1) securing roller blind cover.
Remove cover (2).







Release roller blind from guide rails (1).
Release guide clips (2) from roller blind.
Allow roller blind (3) to roll up completely.

Note: During the following operation, do NOT release the roller blind until a locking pin (e.g. paperclip) has been inserted in the spring mechanism.







Hold roller blind (1) and slide blind in desired direction until end (2) is released from sunroof housing.
Slowly move roller blind in opposite direction until locking pin (4) is inserted at end (3).
Remove roller blind in direction of arrow (5).

Installation: Lubricate new guides with grease.