Engine Control Module: Service and Repair

Removing And Installing Or Replacing Control Unit (COOPER S)


NOTE: Read out fault memory of EMS2000 control unit, check stored fault memory, rectify faults, clear fault memory.


Turn off ignition.
Remove EMS2000 control unit cover.







Move EMS2000 retaining clips (1) and lift EMS2000 control unit upwards.
Slide connector locking mechanism (2) outward.
Disconnect EMS2000 connectors.
Program control unit with DIS+ or MoDic.
Programming.
DME programming.
Exchange control unit.
Engine type.
Exchange control unit.


NOTE: Read out fault memory of EMS2000 control unit, check stored fault memory, rectify faults, clear fault memory.